Installing Projector Mount - PEERLESS PRS-EXA Installation And Assembly Manual

Installing Projector Mount

4
Installing PRS projector mount with ceiling installation: Attach vertical mounting plate (EE) to PRS projector
mount (A) using two M5 x 16 mm socket pin screws (GG), two flat washers (F) and two locknuts (KK) as shown in
figure 4.1.
Installing PRS projector mount with wall installation: Position PRS projector mount (A) to the orientation
shown in figure 4.2 and attach to horizontal mounting plate (FF) using two M5 x 16 mm socket pin screws (GG),
two flat washers (F) and two locknuts (KK).
Note: Placing screws (GG) and washers (F) through slots on inside of PRS projector mount and attaching
horizontal mounting plate from the bottom can make installation easier as shown in figure 4.3.
CEILING INSTALLATION
fig. 4.1
A
HOLE INDICATES
FRONT OF MOUNT
fig. 4.3
5 Ceiling installation: Insert vertical mounting plate (EE) into inner channel (CC) with projector mount (A)
in the correct orientation shown in figure 5.1. Secure vertical mounting plate to inner channel using four
socket pin screws (JJ) as shown in figure 5.2.
fig. 5.1
A
HOLE
INDICATES
FRONT OF
MOUNT
Visit the Peerless Web Site at www.peerlessmounts.com
KK
EE
F
GG
A
CC
EE
WALL INSTALLATION
(EXCEPT FOR EXC MODELS)
fig. 4.2
A
HOLE INDICATES
FRONT OF MOUNT
fig. 5.2
EE
9 of 13
PLACE SCREWS (GG) AND
WASHERS (F) FIRST
GG
F
CC
JJ
ISSUED: 04-24-08 SHEET #: 055-9256-1
For customer care call 1-800-865-2112 or 708-865-8870.
KK
FF
F
GG