Add/Edit Port Forwarding - ZyXEL Communications EX5501-B0 User Manual

Table 58 Network Setting > NAT > Port Forwarding (continued)
LABEL
Translation End
Port
Protocol
Modify

11.2.1 Add/Edit Port Forwarding

Click Add New Rule in the Port Forwarding screen or click the Edit icon next to an existing rule to open
the following screen. Specify either a port or a range of ports, a server IP address, and a protocol to
configure a port forwarding rule.
Note: To configure port forwarding, you need to have the same configurations in the Start
Port, End Port, Translation Start Port, and Translation End Port fields.
Note: To configure port translation, you need to have different configurations in the Start Port,
End Port, Translation Start Port, and Translation End Port fields.
Note: TCP port 7547 is reserved for system use.
Chapter 11 Network Address Translation (NAT)
DESCRIPTION
This is the last internal port number that identifies a service.
This shows the IP protocol supported by this virtual server, whether it is TCP, UDP, or TCP/UDP.
Click the Edit icon to edit this rule.
Click the Delete icon to delete an existing rule.
EX5501-B0 / AX7501-B0 / PX7501-B0 User's Guide
174