ZyXEL Communications EX5501-B0 User Manual page 146

Figure 84 Network Setting > Routing > Static Route: Add/Edit
The following table describes the labels in this screen.
Table 41 Network Setting > Routing > Static Route: Add/Edit
LABEL DESCRIPTION
Active Click this switch to enable or disable this static route. When the switch goes to the right
function is enabled. Otherwise, it is not.
Route Name Enter a descriptive name for the static route.
IP Type Select whether your IP type is IPv4 or IPv6.
Destination IP Enter the IPv4 or IPv6 network address of the final destination.
Address
Subnet Mask If you are using IPv4 and need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the host
ID. Enter the IP subnet mask here.
Use Gateway IP The gateway is a router or switch on the same network segment as the device's LAN or WAN
Address port. The gateway helps forward packets to their destinations.
Click this switch to enable or disable the gateway IP address. When the switch goes to the right
, the function is enabled. Otherwise, it is not.
Gateway IP Enter the IP address of the gateway.
Address
Use Interface Select the WAN interface you want to use for this static route.
Cancel Click Cancel to exit this screen without saving any changes.
Apply Click Apply to save your changes.
EX5501-B0 / AX7501-B0 / PX7501-B0 User's Guide
Chapter 9 Routing
146
, the