Replacing Conditioner Tines - SaMASZ KT 261 Operator's Manual

Fig. 31b. Adjusting conditioner plate (for mowers: KT 261 S (H), KT 301 S (H))

6.8. Replacing conditioner tines

(For mowers:
KT 261 S (H), KT 301 S (H), KT 260 S (H), KT 300 S (H))
Before any operation, on each occasion check condition of bolts, on which tines are set, as
well as condition of tines themselves. If either is worn or damaged, replace them. Bear in mind,
that tines should be replaced in pairs (opposite) of the same weight in order to keep the shaft
well balanced. Otherwise bearings and the shaft itself may be exposed to premature wearing.
1. Conditioner's shaft
2. Self-locking nut gal. cl. 8.8
3. Tine
4. Special truss head bolt
M16x16 gal. cl. 10.9 with neck
Operating manual
Fig.
31a. Adjusting conditioner guard
+
-
Fig. 32a. Replacing conditioner tines
Rear disc mower with central suspension
- hydro-pneumatic or spring suspension
+
„+" - increasing plate -
conditioner clearance width
„-" - reducing plate –
-
conditioner clearance width
+
-
„+" - increasing plate -
conditioner clearance width
„-" - reducing plate –
conditioner clearance width
- 4 1 -
1
2
3
4