Warning, Safety & Maintenance; Maintenance Schedule - Cortex Omega TAR-10 Owner's Manual

WARNING, Safety & Maintenance
Be sure that all users carefully read and understand all
warning, safety and maintenance info on this Owner's
Manual or labels on the machine before each use. Failure to
do so may result in death or serious injury.
It is imperative that you retain this Owner's Manual and be
sure all warning labels are legible and intact.
If you have any questions about the operation, set up or
maintenance of this machine please contact the local
distributors or sales agents.
THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS
TYPE OF EQUIPMENT.
TO MINIMIZE RISK, YOU MUST FOLLOW THESE RULES:
1. Inspect equipment before each workout. Check that all
nuts, bolts, screws and pop pins are in place and fully
tightened. Also, before use, check cables for signs of wear.
Replace all worn parts immediately. Never use machine if
any parts are damaged or missing.
FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS
INJURY.
2. Keep clear of the cables and all moving parts when the
machine is in use.
3. Always make sure all Snap Links are closed when doing
any cable/pulley/strap exercises.
4. Exercise with care. Perform your exercises at a smooth
moderate pace; never perform jerky or uncoordinated
movements that may cause injury.
5. It is recommended that you should workout with a
training partner.
6. Do not allow children or minors to play on or around this
equipment.
7. If unsure of proper use of equipment, call your local
distributor or agent.
8. WARNING: Consult your physician before starting your
exercise program. For your own safety, do not begin any
exercise program without proper instruction.
MAINTENANCE
SCHEDULE
Check the function and integrity of the
following components.
As noted, inspect equipment before
each workout. Replace all damaged,
broken or
immediately.
Cables:
Upholstery:
Frame:
Chrome:
Nuts/ Bolts/
Tighten and/
needed
Guide Rods:
Linear
Rods:
Seat
Sleeves:
Adjustments/ Locking Pins/
Tightening Knobs
Weight Stack Pins
Warning Instruction Labels
Springs/ Pop Pins
Anti Skid Surfaces
Hand Grips/ Rollers
- 1 -
worn components
Check tension,
end fittings, and
coating
Check that
locking nut at
weight stack is
tight
Wipe down and dry
Clean and
condition
Wipe down and dry
Polish / Wax
Wipe down and dry
Polish /
Lubricate
Fasteners:
or adjust as
Lubricate and
clean
Lubricate and
clean
Lubricate and
clean
W
D
E
A
E
I
K
L
L
Y
Y
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√