Sony Ericsson S700i Working Instruction, Mechanical page 6

Step-by-Step Instructions
8 Open the lower cabinet cautiously.
9 NOTE!
Be careful not to damage the circuit board with
the opening tool.
With the front opening tool, release catches that
hols the main PBA in the case key front. Start
like the picture show (1).
If necessary do the same thing on the other side
(2). (make sure to avoid prying on the flex films)
NOTE!
Sometimes it helps if you bend the frame a little
side to side.
10
To remove the main PBA, lift the camera end of
the circuit board away from the case key front as
high as it will easily move.
With the PBA in the lifted position, wiggle the
board back and forth while pulling the board
away from the system connector.
NOTE!
Don't bend the circuit board to much upwards.
11 NOTE!
Always be careful with the "two main cables"
(Harness) (1).
Open out the main PBA from the frame
NOTE! VERY IMPORTANT!
Remember how the two main cables (Harness)
are assembled "with a twist/crossover" to the
main PBA
3/00021-1/FEA 209 544/89 B

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
6(51)