Sony Ericsson S700i Working Instruction, Mechanical page 16

Step-by-Step Instructions
12 NOTE!
When reassembling the two main cables
(harness) to the main PBA start like the picture
shows.
The left cable (L) should go to the left connector
on the PBA (See picture 13).
The right cable (R) should go to the right
connector on the PBA (See picture 13).
13 Place the main PBA against the case key front
like the picture shows; start to connect the two
cables to respectively left and right ZIF
connector.
Take notice of the "crossover" (1).
14 NOTE!
1. Be careful not to damage the two main cables
and the connectors with the tweezers.
2. Notice on the two small "knobs" (1) on the
UPPER side on the connector – they must be
directed like the pictures shows when they are
reassembled.
Assemble the two main cables with a blunt pair
of tweezers. Use your markings so they don't get
mixed up (2).
Gently assemble the two cables in their clips (3).
15 NOTE!
After reassembling of the two ZIF-connectors it
should look like this "with a crossover" (1)
before you completely fold down the main PBA
towards the case key front.
Then carefully fold the main PBA over towards
the case key front and start to slide it into the
system connector.
3/00021-1/FEA 209 544/89 B

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
16(51)