Sony Ericsson S700i Working Instruction, Mechanical page 17

Step-by-Step Instructions
16 NOTE!
Before you slide the main PBA to the bottom of
the system connector, check all flexfilm
connections, key buttons and the two main
cables are folded correctly so nothing get
squeezed or damaged between the PBA and the
case key front frame.
Slide the main PBA into the system connector.
17 Place the main PBA completely into the case
key front.
Press gently on the PBA edges with your hand
(by the arrows).
NOTE!
Make sure that the main PBA is mounted
correctly in the case key front.
18 NOTE!
Open out the phone 180º.
Assemble the case key rear over the case key
front and gently snap them together.
NOTE!
Check so the lower cabinet is properly
assembled – there should be no gaps along the
sides.
19 NOTE!
Use 20 Ncm of torque for the case key rear
screws.
Assemble four new screws. Tighten the case key
rear screws according to screw sequence shown
in the picture.
Turn the phone around.
3/00021-1/FEA 209 544/89 B

Company Internal Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
17(51)