ECM02251
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
1. Cooling water pilot hole
EMU27671
Warming up engine
EMU47821
Procedure for warming up engine
After the engine has started, warm up the en-
gine until the engine speed settles at idling
speed.
The engine warm-up indicator " " appears
while the engine is being warmed up and
goes off when warming-up is finished.
1
1
1. Engine warm-up indicator
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU41821
Stop switches
Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
Check that the engine stops when the main
switch is turned to the "
or press the Start/Stop button.
Check that the engine stops when the clip
is pulled from the engine shut-off switch.
Check that the engine cannot be started
with the clip removed from the engine shut-
off switch.
EMU35127
Shifting
EWM00181
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
Operation
1
" (off) position,
57