Table of Contents
Advertisement
4
1. Filter housing
2. O-ring
3. Filter cup
4. Water detection switch lead
5.
Drain the water in the filter cup by soak-
ing it up with a rag.
6.
Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing. NOTICE: Be
careful not to twist the water detec-
tion switch lead when screwing the fil-
ter cup onto the filter housing.
1
2
3
1. O-ring
2. Filter cup
3. Water detection switch lead
7.
Connect the water detection switch cou-
pler securely until a click is heard.
8.
Install the top cowling.
9.
Turn the main switch to the "
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
1
2
3
ZMU07790
EMU41261
If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely checked.
[ECM01971]
ZMU07791
" (on) po-
Trouble Recovery
arator-alert indicator blinks or the buzzer
sounds, have your Yamaha dealer check
the outboard motor. NOTICE: Although
the buzzer will stop when the engine is
started and the remote control lever is
moved to the forward or reverse posi-
tion, do not use the outboard motor.
Otherwise, serious engine damage
could occur.
[ECM02391]
Treatment of submerged out-
board motor
[ECM02321]
103
Advertisement
Table of Contents
