Xilinx ZCU102 Manual page 17

Maxim PowerTool
Power off the ZCU102
Remove jumper J153
Wait 30 seconds
Power on the ZCU102 once more to verify
If the Dashboard does not refresh automatically:
– Click the "Search for Devices" button
– Note that the VFMC_ADJ_10A (located at 0x18) voltage rail will remain disabled –
this is by design
Verify that all Power Good LEDs on the ZCU102 are on
Verify that the FPGA power good LED is green
Open the Maxim PowerTool GUI to verify the correct voltages
on 12V (Input Voltage) and all FPGA rails (Output Voltage)
– You should see 14 rails: 13 green LEDs and 1 red LED (for 0x18)
Page 17
© Copyright 2016 Xilinx
.