Connection For Power Supply; Test Run - Hanseatic WQP12-7609H User Manual

Page EN-26 Installation, connection and commissioning
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the valve again.

Connection for power supply

WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have see EN-6 taken
note of all the safety instructions and
adhered to them.
Fire hazard!
Do not use multi-socket plugs, mul-
■
ti-socket extension cables, travel
adapters or similar.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of a
sufficient size. (220–240 V~, 50 Hz / 10 A).
– We recommend using a pulse-sensitive re-
sidual current device (RCD).

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the device
functions perfectly.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
For the procedure, see „Dishwasher opera-
tion" on page EN-19.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.