Connection For Power Supply; Test Run - Hanseatic HG6085D137609HW User Manual

Connection for power supply

WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Fire hazard!
Never use multi-socket adapters,
■
multi-socket strips, travel adapters or
the like.
Depending on the recess into which the dish-
washer will be installed, the dishwasher should
be connected before or after installation.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of a
sufficient size (220–240 V~ / 50 Hz / 10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.
Set-up, connection and initial start-up

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent. See chapter"Dishwasher operation"
from page EN-23 for the procedure.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Page EN-33