Gps Interface; Usb Interface; Configuration Interface - bintec elmeg H2 Automotive+ Installation Manual

Table of Contents

Advertisement

Technical information
A.4.5 GPS interface
STANDARDS
SATELLITE CHANNELS
CONNECTOR
ANTENNA
A.4.6 USB Interface
3G USB MODEMS
SPEED
CONNECTOR
A.4.7 Configuration interface
INTERFACES
PROTOCOLS
SPEED
CONNECTOR
36
NMEA.
Maximum 30 channels (16 GPS, 14 GLONASS) simultaneous tracking.
RF FME male.
3.3 V Active.
Passive.
Please visit the bintec elmeg GmbH website (http://www.bintec-elmeg.com) for a
list of supported 3G USB modems.
The interface complies with the USB 2.0 (480 Mbps) standard; the end speed de-
pends on the 3G USB modem used.
USB Type A.
This can be configured in two modes:
Asynchronous Port :
V24 DCE. Hardware flow control is not permitted.
Local Console:
V.24 DCE only 8-N-1, without flow control.
Asynchronous Port:
AT, PPP, GPS-DATA.
Asynchronous Port:
300 at 115,200 bps.
Local console:
9,600 bps (configurable up to 115,200).
DB9 female located on the front panel of the device.
bintec elmeg GmbH
bintec H2 Automotive+

Advertisement

Table of Contents
loading

Table of Contents