Installing The Sim - bintec elmeg H2 Automotive+ Installation Manual

bintec elmeg GmbH
Warning
This router is compatible with 1.8 V and 3 V SIM cards. Do not install SIMs that do not support these
voltages.
Never install a SIM card when the device is switched on.
Always disconnect the router from the main power supply before installing a SIM card.
Always disconnect the device before removing the casing to access the trays.
Protect yourself against electrostatic discharges (ESD) when inserting a SIM card.
Do not touch the SIM card connectors.

3.7.1 Installing the SIM

To insert a SIM card into a SIM tray, first place the router on a stable surface with the rear panel facing towards you
(as shown in the following figure) and then follow the instructions given below:
SIM trays
Fig. 19:
Unscrew the protective cover to access the SIM trays.
To install the SIM, follow these steps:
(1) Press the button until the SIM tray slides out of the slot.
(2) Flip horizontally.
(3) Place the SIM card on the tray. Make sure that the SIM card is properly inserted in its tray.
(4) Flip horizontally.
(5) Slide the tray into the slot by pushing it in.
Finally, screw the protective cover back in place.
bintec H2 Automotive+
3 Components and power supply
19