Rebooting The Device; Default Configuration; Plug-In Modules; Installation - bintec elmeg H2 Automotive+ Installation Manual

Table of Contents

bintec elmeg GmbH

3.4.1 Rebooting the device

Once the device is operating normally, press the RST button to reboot.

The RST button allows you to restore your router to its default configuration. Follow these steps to reset your router:

• With the device turned off, press and hold down the RST button while you turn the router on using the ON/OFF

switch (1).

• The PWR LED (red) will light up and the U-LED will start blinking (amber). It will blink for 10 seconds.

• To reboot the device with the default configuration, let go of the RST button while the U-LED is still blinking (i.e.,

before the 10-second period expires).

The default configuration sets up the device with the following IP address and access mask:

• IP address: 192.168.1.1

• IP mask: 255.255.255.0

Note

Bear in mind that some devices come with customized settings, so your router's default configuration

may be different from the one shown above.

The device only accepts 3G USB modems at present. Please refer to the following website for a list of supported 3G

modems: http://www.bintec-elmeg.com.

To install the USB modem, simply insert it in the USB connector (as shown in the following figure):

USB modem slot

Fig. 12:

To remove the device, gently pull it out of the slot where it was inserted.

The bintec H2 Automotive+ has the following data connections.

bintec H2 Automotive+

3 Components and power supply

Table of Contents