Mic Jumper Options; 10Base-T Mic Jumper Settings; 10Base2 Mic Jumper Settings - GE D20 Installation And Operation Manual

GE Energy
Connections and Configuration
MIC Jumper Each of the two channels on the MIC includes a set of jumpers to enable or disable
Options various operational modes.
Note:
10BASE-T The following table specifies the jumper settings to enable or disable the various
MIC Jumper operational modes of each of the two channels of the 10BASE-T MIC:
Settings
Note:
1-2
Out
Out
Out
In
10BASE2 MIC Each of the two channels of the 10BASE2 MIC includes a jumper to enable and
Jumper disable SQE Test.
Settings
Note:
Channel 1 Mode Jumpers
Channel 2 Mode Jumpers
General
Full
, continued
The three module types have different jumper configurations, so be sure to
use the correct table for your module.
The default jumper setting is: JP1 and JP2 jumpers 7-8 In, all other
jumpers Out, disabling the SQE Test mode.
This is the mode usually used with 10BASE-T Ethernet hub networks.
Jumper JP1 (Ch 1)
and JP2 (Ch 2)
3-4 5-6 7-8
Out Out In
Out In Out
In Out Out
Out Out Out
The default setting is SQE Test Enabled for both channels.
Jumper Position
JP1 – Out
JP1 – In
JP2 – Out
JP2 – In
Installation and Operations Guide
Mode of Operation
SQE Test Link Test
Disabled Enabled
Disabled Disabled
Enabled Disabled
Enabled Enabled
Mode of Operation
SQE Test Enabled
SQE Test Disabled
SQE Test Enabled
SQE Test Disabled
994-0078-2.00-7
D20/D200
Jabber
Enabled
Disabled
Enabled
Enabled
81