Termination Panels: Jumper Settings; Termination Panels: Power Supply; Westerm D20M+Ss: Power Supply - GE D20 Installation And Operation Manual

GE Energy
Connections and Configuration
Termination There are three WESTERM Termination Panels. For jumper configuration settings
Panels: Jumper for each of these boards see the Module Layout drawings:
Settings
•
WESTERM D20M+ SS for non-VME see 517-0224-ML
•
WESTERM D20M+ for VME see 517-0225-ML
•
WESTERM D20M++ for VME see 517-0245-ML
Termination Power connections to the WESTERM Termination Panels are made on connector
blocks:
Panels: Power
Supply
•
TB1 on the WESTERM D20M+ SS and WESTERM D20M+
•
TB2 on the WESTERM D20M++
WESTERM Power Supply connections on WESTERM D20M+ SS and WESTERM D20M+:
D20M+SS:
Power Supply
•
1 & 2 are used for input power connections based on the WESDAC D20 Power
Supply
•
4 & 5 can be used as a switched auxiliary power supply source
•
7 & 8 can be used externally for status wetting, contact wetting and/or
miscellaneous power connections, if applicable.
General
Full
, continued
994-0078-2.00-7
D20/D200
Installation and Operations Guide
53