D20/D200
Installation and Operations Guide
D20/D200 Software Configuration
D20ME II VME modules can be used in a multi-node VME system, known as a
About Multi-
Node
D200. The application code for each D20ME II module in a multi-node system can be
Downloads
the same or different for one or more of the modules.
The download procedure is the same for a multi-node system as for a single node;
repeat the procedure for each node.
Note:
D20EME
If you have installed the D20EME for global memory expansion of your D20/D200
Global Memory
system, you must configure the parameters for this in Config Pro:
Expansion
•
Memory starting address
•
Size of Global Memory
Consult the On Line Help in Config Pro for how to do this.
D20EME
If you have installed the D20EME for Ethernet interface capability on your
Ethernet
D20/D200 system, you must enable the LAN interface and configure the parameters
for this in Config Pro:
Interface
•
IP and Ethernet addressing
•
BootP settings
•
Single or dual LAN selection
Consult the On Line Help in Config Pro for how to do this.
114
, continued
Do not restart (i.e. Boot) the multi-node system until you have finished
downloading code to all the D20ME II cards.
994-0078-2.00-7
GE Energy
General
Full