D.20 Interface Modules; D.20 Comm Interface: Jumpers - GE D20 Installation And Operation Manual

D20/D200
Installation and Operations Guide
Connections and Configuration
D.20 Interface Jumper location and configuration settings for the D.20 Communication Interface
Modules and D.20 DC Interface are given below. You can also refer to the Module Layouts
for these boards:
•
D.20 Communications Interface and D.20 RS-485 Adaptor
− see 520-0117-ML
•
D.20 Splitter
− see 520-0118-ML
•
D.20 DC Interface
− see 520-0154-ML
D.20 Comm Jumper locations on the D.20 Communications Interface:
Interface:
Jumpers
Z5 & Z6
Use jumpers:
•
Z1 to Z4 for external power setting
•
Z5 and Z6 for D.20 channel used
•
Z7 and Z8 for Repeater channel used
•
Z9 to Z14 for SW base compatibility setting
See table below, next page.
74
, continued
Z9 to Z12
Z1 to Z4
994-0078-2.00-7
GE Energy
Z13 & Z14
Z7 & Z8
General
Full