GE Energy
D20/D200 Software Configuration
Setup
To set up a PC to act as a WESMAINT II+ terminal, see "Power-up and Test", page
WESMAINT
89.
II+ terminal
Procedure:
If the D20ME BootROM Base Type is already known, skip this procedure.
Identify Base
Step
1
2
D20ME: Flash
The following table shows possibles allocation of the 2 MB FLASH memory. Check
Memory
that the settings for memory mapping in Config Pro match the allocation.
D20 Base
CCU Base
General
Full
, continued
Configure and Connect PC to D20ME
Connect a WESMAINT cable from the PC's com port to the D20ME
front panel WESMAINT port.
Restart the D20ME (power off-on cycle) while watching the PC monitor.
If the first line of output text is:
P149-0 D20ME BOOTROM
P130-0, GE Energy Services CCUME BootROM
Software
Allocation
1MB or 2MB
1MB or 2MB
Installation and Operations Guide
Action
Identify D20ME Type
Typical Allocation
1MB is the typical allocation for this Base
2MB is the typical allocation for this Base
994-0078-2.00-7
D20/D200
Board type is:
D20 Base
CCU Base
101