Safety Procedures And Warnings - Aerotech AGV3D Series Hardware Manual

Safety Procedures and Warnings

Safety Procedures and Warnings
This manual tells you how to carefully and correctly use and operate the AGV3D.
l
l
If you do not understand the information in this manual, contact Aerotech Global Technical
Support.
N O T E : Aerotech continually improves its product offerings; listed options may be superseded at any
time. All drawings and illustrations are for reference only and were complete and accurate as of this
manual's release. Refer to www.aerotech.com for the most up-to-date information.
D A N G E R : Reduce the possibility of electrical shock, bodily injury, or death. This product
contains potentially lethal voltages.
l
l
l
l
connected to a power source.
l
power source.
l
requirements.
l
product.
D A N G E R : Lasers.
l
l
exposure to direct or scattered radiation.
D A N G E R : Compressed Air.
l
l
protection.
W A R N I N G : To prevent damage to the equipment:
l
l
l
specifications. Exceeding environmental or operating specifications can cause damage to
the equipment.
6
Read all parts of this manual before you install or operate the AGV3D or before you do
maintenance to your system.
To prevent injury to you and damage to the equipment, obey the precautions in this
manual.
Operators must be trained before operating this equipment.
All service and maintenance must be performed by qualified personnel.
Disconnect electrical power before servicing equipment.
Do not connect or disconnect any electrical components or connecting cables while
Restrict access to the AGV3D and component parts while the AGV3D is connected to a
All components must be properly grounded in accordance with local electrical safety
Operator safeguarding requirements must be addressed during final integration of the
Wear eye protection.
Be aware of the possibility of visible and/or invisible laser radiation. Avoid eye or skin
Wear eye protection when in the proximity of compressed air components.
The noise from some compressed air components could be loud enough to require ear
Operators must be trained before operating this equipment.
All service and maintenance must be performed by qualified personnel.
Do not expose this product to environments or conditions outside of the listed
AGV3D Hardware Manual
www.aerotech.com