Table of Contents
Advertisement
AGV3D Hardware Manual
2.3. Remove the Shipping Clamp
Remove the shipping clamp before you mount or operate the AGV3D. Put the AGV3D on a stable, flat
surface for this procedure.
W A R N I N G : You could cause permanent mechanical damage to the AGV3D if you do not
remove the shipping clamp before your operate the AGV3D.
Removing the Shipping Clamp
1. Remove the four [QTY. 4] M3x0.5, 10 mm LG socket head cap screws that attach the top cover of the
main AGV3D enclosure and set them aside.
N O T E : The top cover can not be completely removed because there are cables attached to the under-
side of it.
2. Carefully lift up the top cover from the front to access the shipping clamp.
W A R N I N G : If a cable is damaged or detached in this step, it could cause severe damage to
the AGV3D when it is operated.
3. Loosen the two [QTY. 2] M3 socket head cap screws that hold the shipping clamp in place. Carefully
remove the shipping clamp, the two [QTY. 2] M3 shcs, and the two [QTY. 2] M3 washers as a group to
make sure that you do not drop a screw or washer in the open AGV3D enclosure.
www.aerotech.com
Figure 2-3:
Top Cover Removal
2.3. Remove the Shipping Clamp
27
Advertisement
Table of Contents
