Unpacking And Handling The Scan Head - Aerotech AGV3D Series Hardware Manual

2.1. Unpacking and Handling the Scan Head
2.1. Unpacking and Handling the Scan Head
W A R N I N G : To prevent the accumulation of condensation on the optical surfaces, allow the
shipping case to sit at room temperature before you open it.
W A R N I N G : It is the customer's responsibility to safely and carefully lift and move the scan
head. Improper handling could adversely affect the performance of the AGV3D
l
parts may shift and cause bodily injury.
l
l
l
l
protect the optics.
W A R N I N G : Fingerprints contain aggressive substances that can damage optical surfaces.
Always wear suitable gloves when you handle the optics.
Carefully remove the AGV3D from its protective shipping container. Gently set the AGV3D on a smooth,
flat, and clean surface.
Before operating the AGV3D, it is important to let it stabilize outside of the shipping case at room
temperature for at least 12 hours. Allowing it to stabilize to room temperature will ensure that all of the
alignments, preloads, and tolerances are the same as they were when tested at Aerotech. Use compressed
nitrogen or clean, dry, oil-less air to remove any dust or debris that has collected during shipping.
Each AGV3D has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference.
24
Make sure that all moving parts are secure before moving the AGV3D. Unsecured moving
Do not use the cables or tubing as a lift surface.
Do not use the focal lens or exit aperture as a lift surface.
Make certain that the lens cap is attached before moving the AGV3D.
Only put the scan head on a soft surface when it is not attached to its mounting surface to
AGV3D Hardware Manual
www.aerotech.com