Aerotech AGV3D Series Hardware Manual page 49

AGV3D Hardware Manual
Cleaning Procedure
1. Use compressed nitrogen or clean, dry, oil-less air to remove any loose particles from the surface.
2. Moisten an appropriate lint-free lens cleaning cloth with isopropyl alcohol.
3. Fold the cloth over such that one folded (straight) edge will serve as the leading edge during the
wiping motion.
4. Place the folded (straight) edge of the cloth onto one end of the optical surface. Applying very
minimal pressure, slowly move the cloth over the optical component to the opposite end. Never
bear down hard, scrub, or wipe in a circular motion when cleaning an optical surface.
5. Remove any liquid residue with a dry lint-free lens cleaning cloth or by blow it off in one direction
with compressed nitrogen or clean, dry, oil-less air.
6. Repeat this procedure, using a new lint-free lens cleaning cloth for each repetition, until the surface
is completely clean.
N O T E : Contact Aerotech if you need a replacement Protective Window.
www.aerotech.com
4.2.1. Protective Windows
49