Remove The Shipping Clamp; Figure 2-3: Top Cover Removal - Aerotech AGV3D Series Hardware Manual

Three-axis laser scan head
Hide thumbs Also See for AGV3D Series:
Table of Contents

Advertisement

AGV3D Hardware Manual

2.3. Remove the Shipping Clamp

Remove the shipping clamp before you mount or operate the AGV3D. Put the AGV3D on a stable, flat
surface for this procedure.
WARNING: You could cause permanent mechanical damage to the AGV3D if you do not
remove the shipping clamp before your operate the AGV3D.
REMOVING THE SHIPPING CLAMP
1. Remove the four [QTY. 4] M3x0.5, 10 mm LG socket head cap screws that attach the top cover of
the main AGV3D enclosure and set them aside.
2. Carefully lift up the top cover from the front to access the shipping clamp.
NOTE: The top cover can not be completely removed because there are cables attached to the
underside of it.
WARNING: If a cable is damaged or detached in this step, it could cause severe damage to
the AGV3D when it is connected to a power source.
3. Loosen the two [QTY. 2] M3 socket head cap screws that hold the shipping clamp in place.
4. Carefully remove the shipping clamp, the two [QTY. 2] M3 shcs, and the two [QTY. 2] M3 washers
as a group to make sure that you do not drop a screw or washer in the open AGV3D enclosure.
www.aerotech.com
Figure 2-3:
Top Cover Removal
2.3. Remove the Shipping Clamp
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Agv3d-20Agv3d-30

Table of Contents