Specification, Relay Contact Rel Output (X5); Specification, Connection "State" (X6); Commissioning; Connection Examples, Supply Unit - Keba ServoOne CM-P BG1 Operation Manual

Electrical installation 1 Electrical installation
ID no.: 1400.201B.5-00
NOTE:
Connections X3 are used only for internal communication between supply unit
and axis controller.

4.13.2 Specification, relay contact REL Output (X5)

Des. Term. Specification
RO02CO
RO02NO = normally open
X5
RO02NO
contact
NOTE:
For switching inductive loads (e.g. auxiliary contactors) on X5, we recommend
the usage of suppressors (AC-operated contactors) or free-wheeling diodes
(DC-operated contactors) on their control coils.

4.13.3 Specification, connection "State" (X6)

Des. Term. Specification
RO01NC = normally closed
contact
RO01NC
RO01CO = changeover
RO01CO
X6
contact
RO01NO
RO01NO = normally open
contact
Signal driver outputs for
TP00 = test pulse signal
internal usage for short-
00
circuit and cross-circuit
X6 TP01 = test pulse signal
checks on the wiring to
01
the safe inputs on the axis
GND = reference ground
controllers
Date: 02/2020
Details
Relay contact for low-voltage circuit:
≤ 250 V AC or ≤ 30 V DC, 1.5 A
max. each,
contact freely programmable
Factory setting = Operation of main
contactor
Details
Signal relay contact for PELV circuit:
≤ 25 V AC or ≤ 30 V DC, 0.5 A max.
each (only ohmic load),
contact freely programmable
Factory setting = Active on error
See
Model Description SD0
ID no. 1400.402B.x-xx
Operation Manual Supply Unit SO CM-P BG1+2

4.14 Commissioning

You will find a description of commissioning in the Operation Manual ServoOne CM Axis
Controller chapter 4.

4.15 Connection examples, supply unit

The supply unit can be operated on supply systems with 3 x 230V, 3 x 400 V and 3 x
480 V. For connection examples, see next page.
NOTE:
A maximum of 8 axis controllers (this corresponds to maximum 24 axes) can
be connected and operated on one ServoOne CM-P Supply Unit .
36