Overview Of Busbars In The Group; Control Connections (Front Panel); Specification, Cross-Communication (X3) - Keba ServoOne CM-P BG1 Operation Manual

4.12.3 Overview of busbars in the group

A
Figure 4.15 Cover on the busbars
WARNING! Risk of injury due to electrical power!
Carelessness may result in serious injuries or death.
x The multi-axis system is only allowed to be operated with the cover on the busbars closed! It
is also important that the side covers (A) are fitted. Both provide protection against touching
bare and live parts.
ID no.: 1400.201B.5-00
Electrical installation 1 Electrical installation
A
Date: 02/2020

4.13 Control connections (front panel)

Step Action
Make a connection between the connection X3 on the supply unit
1.
and X3 on the first axis controller (cross-communication).
If necessary wire the programmable relay contacts X5 and X6 as
2.
well as the test pulse outputs TP01 and TP02.
3.
Check all connections again!
Figure Abbreviation
ERR
Voltage
X5 / REL Output
RO01NC TP00
RO01CO TP01
RO01NO GND
X6 / State
Figure 4.16 Layout, supply unit front
RO02CO
RO02NO
X5 / REL Output

4.13.1 Specification, cross-communication (X3)

Des. Term. Specification
Cross-communication output (RJ10 connector), internal
X3 XC Out
RS485 network for communication with axis controllers
Operation Manual Supply Unit SO CM-P BG1+2
Comment
For this purpose use the cable
supplied of type: XCOM
See appendix
Designation
LED red Supply unit error status (flashing
(ERR) code)
LED green
Status mains supply available
(Voltage)
X3 / XC OUT Cross-communication
Relay contact (RO02)
Relay contact (RO01)
X6 /State
Digital outputs (TPO1, TPO2)
Details
See
Operation Manual SO CM
ID. no. 1400.200B.x-xx
35