Western Digital ActiveScale X100 Installation Manual page 55

ActiveScale™ X100 Installation Guide
The figure below illustrates the location of the eth2 port.
Figure 5-55. System Node eth2 Port
b. Give your laptop an IP address in the same range as System Node 1's default link local IP address
for eth2, 169.254.140.1.
For example,
Laptop IP address: 169.254.140.2
Subnet mask: 255.255.255.0
Gateway: 169.254.140.1
c. Ping 169.254.140.1 from your laptop, to confirm that you can reach it.
If ping results do not confirm a connection, review your laptop's network configuration.
2. At each site, using a supported web browser, navigate to https://169.254.140.1:10443/.
Note: ActiveScale SM is compatible with Chrome v63-65 and Firefox v57-59.
Desktop versions only.
The pre-login configuration wizard's Introduction page appears at each site.
Figure 5-56. Pre-Login > Introduction
55