Mgmt Services For Ip Passthrough - ZyXEL Communications LTE Series User Manual

The following table describes the fields in this screen.
Table 58 Maintenance > Remote Management
LABEL
WAN Interface
used for services
Cellular WAN
Service
LAN/WLAN
WAN
Trust Domain
Port
Cancel
Apply

20.3 MGMT Services for IP Passthrough

Configure which interface(s) you can use to access the Zyxel Device in IP Passthrough mode (bridge
mode) for a given service. You can also specify the service port numbers computers must use to
connect to the Zyxel Device. IP Passthrough allows Internet traffic to go to a LAN computer behind the
Zyxel Device without going through NAT. Make sure to enable IP Passthrough in Network Setting >
Broadband > Cellular IP Passthrough. See
Click Maintenance > Remote Management > MGMT Services for IP Passthrough to open the following
screen.
Figure 99 Maintenance > Remote Management > MGMT Services for IP Passthrough
Chapter 20 Remote Management
DESCRIPTION
Select Any_WAN to have the Zyxel Device automatically activate the remote management
service when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the Zyxel Device
activate the remote management service when the selected WAN connections are up.
Enable the LTE WAN connection configured in
WAN to access the service on the
This is the service you may use to access the Zyxel Device.
Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the LAN/WLAN.
Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from all WAN connections.
Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the trusted host IP address.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes back to the Zyxel Device.
LTE Series User's Guide
Network Setting > Broadband > Cellular
.
Zyxel Device
Section 5.6 on page 41 for details.
130