Using The Wifi Button - ZyXEL Communications LTE Series User Manual

The following table describes the items on the bottom panel.
Table 2 Panel Ports and Buttons
LABEL
LAN
WiFi
WPS
Reset
Reboot
SIM card

1.6 Using the WiFi Button

The wireless network is turned off by default.
You can use the wireless function for 30 minutes by default after the Zyxel Device finishes rebooting or
when the wireless function is turned on.
Figure 3 WiFi Button
To turn on WiFi:
Make sure the POWER LED is on and not blinking.
1
Press the WiFi button for more than 5 seconds and release it.
2
Once WiFi is turned on, the LED blinks amber.
To activate WPS (WiFi must be already on):
Press the WiFi button for more than 1 second but less than 5 seconds and release it (pressing more than
1
5 seconds will turn off WiFi).
Press the WPS button on another WPS-enabled device within range of the Zyxel Device.
2
To turn off the wireless network, press the WiFi button for more than 5 seconds.
The amber LED turns off.
Chapter 1 Introduction
DESCRIPTION
Connect a computer via the PoE injector for configuration.
Connect the PoE injector to a power outlet to start the device.
Press the WLAN button for more than five seconds to enable the wireless function.
After the wireless function is enabled, press the WLAN button for more than one second but less
than five seconds to quickly set up a secure wireless connection between the device and a WPS-
compatible client.
Press the button for more than five seconds to return the Zyxel Device to the factory defaults.
Press the RESET button for more than 2 seconds but less than 5 seconds, it will cause the system to
reboot.
Insert a micro-SIM card into the slot with the chip facing down and the beveled corner in the top
left corner.
LTE Series User's Guide
15