Mgmt Services For Ip Passthrough - ZyXEL Communications LTE Series User Manual

The following table describes the fields in this screen.
Table 69 Maintenance > Remote Management
L ABEL
WAN Interface
used for services
Cellular WAN
ETHWAN
Service
LAN/WLAN
WAN
Trust Domain
Port
Apply
Cancel
22.3 MG MT Se rvic e s fo r IP Pa ssthro ug h
Configure which interfaces you can use to access the Zyxel Device in
mode) for a given service. You can also specify the service port numbers computers must use to
connect to the Zyxel Device. IP Passthrough allows Internet traffic to go to a LAN computer behind the
Zyxel Device without going through NAT. Make sure to enable IP Passthrough in
>
Bro a db a nd
Click
Ma inte na nc e > Re m o te Ma na g e m e nt > MG MT Se rvic e s fo r IP Pa ssthro ug h
screen.
Chapter 22 Remote Management
DESC RIPT IO N
Select to have the Zyxel Device automatically activate the remote management
Any_WAN
service when any WAN connection is up.
Select and then select one or more WAN connections to have the Zyxel Device
Multi_WAN
activate the remote management service when the selected WAN connections are up.
Enable the LTE WAN connection configured in
access the service on the Zyxel Device.
Enable the LTE WAN connection configured in
access the service on the Zyxel Device.
This is the service you may use to access the Zyxel Device.
Select the check box for the corresponding services that you want to allow access to the
Ena b le
Zyxel Device from the LAN/WLAN.
Select the check box for the corresponding services that you want to allow access to the
Ena b le
Zyxel Device from all WAN connections.
Select the check box for the corresponding services that you want to allow access to the
Ena b le
Zyxel Device from the trusted host IP address.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Click to save your changes back to the Zyxel Device.
Apply
Click to restore your previously saved settings.
C a nc e l
. See
C e llula r IP Pa ssthro ug h
LTE Series User's Guide
Ne two rk Se tting > Bro a db a nd > C e llula r WAN
Ne two rk Se tting > Bro a db a nd > C e llula r WAN
Section 6.8 on page 73 for details.
169
mode (bridge
IP Pa ssthro ug h
Ne two rk Se tting
to open the following
to
to
>