GE eBike Service Manual page 62

3.c Calibration of output for analog RPM
In order to calibrate the analog RPM signal the
ergometer output voltage, e.g. 1000 mV and
the corresponding RPM value, e.g. 100 rpm
are set at the ergometer: Select requeting setting (see 3.a) and
confirm with "SET".
GAIN: range up to 1000 mV in steps of 10 mV
GAIN: range from 30 to 130 rpm in steps of 10 rpm
4. EKG remote start
Leadtime is the lead time for the EKG remote start signal, i.e., when
the implemented exercise protocols control the ergometer, these
protocols trigger the remote start signal before a load change.
Pulsewidth indicates the width of the remote start pulse.
range from
range from
5. NIBP Parameter
Leadtime determines the lead time of a BP measurement before a
load change when the ergometer is controled by the implemented
exercise protocols (WHO, Hollmann, ...).
range from 40 to 90 seconds in steps of 1 second
Resting NIBP determines whether or not a BP measurement will be
performed before the ergometry is started. This setting only effects
the "ergometry" mode. Preferred and default setting is "ON"
range
6. Software Update
Note: If the eBike has the serial no range beginning with:
2004000268 up to 2004001139
The Flash Eprom in the eBike Terminal has to be replaced. The
Software Version 1.2 or higher is only running with the new Flash
Eprom. eBike's with serial no higher 2004001139 has already this
new Flash Eprom implemended.
For update the Flash Eprom please order update Kit
2018111-058 SPARE EBIKE FLASH UPDATE KIT. This update
Kit includes also the update instruction.
Note: Software updates are performed via the RS232 interface of a PC,
using a special update program.
A null modem cable, e.g. 223 362 03 between PORT 2 (9-pin
SUB-D socket at ergometer) and the RS232 interface at the PC is
required for the update.
- 56 -
D: Service Menu
1 to 30 seconds in steps of 1 second
100 to 1000 ms in steps of 100 ms
OFF - ON
eBike, eBike L, eBike EL 2018112-003 Rev J