GE eBike Service Manual page 22

d. Remove Casing
The shells of the casing must only be removed for repairs on the drive unit and on the power supply.
1. Disconnect device from mains!
2. Remove top cover (see item c.)
3. Take off right and left pedals.
• Remove protective cover from pedals.
• Using the extractor (P/N 2005737-001), unscrew the screw
in the axle and remove (17-mm fork wrench required)
• Screw the extractor at least half way into the pedal axle (see Figure)
Turn the half of the extractor that points away from the axle to the
right until the pedal can be removed.
4. Take off front wheels
• Using a thin screwdriver, carefully unseat the caps covering
the wheels.
• Remove snap ring from wheel retention.
• Take off both wheels.
• Unscrew screw of the threaded bolt on one side at the front
and remove threaded bolt.
5. Pull bellows for steering column and saddle over retaining groove.
• Using an Allan key, remove threaded screw of the
steering column and saddle housing (3-mm Allan key
required).
6. Using a long 3-mm Allan key, remove both screws on the right
and left of the drive unit casing.
7. Remove front and rear connection piece.
• Loosen each hexagon socket screw on one side.
• Remove front and rear connection piece.
- 16 -
B: Mechanical Design
eBike, eBike L, eBike EL 2018112-003 Rev J