Advertisement
PARTS REQUIRED:
x1
7/16 x 35-3/8 x 96"
(1,1 x 89,9 x 244 cm)
x2
7/16 x 23-7/8 x 96"
(1,1 x 61 x 244 cm)
Keep spacing between the center of
3
the rafters at the lower edge of the
panel and secure with one 2" nail into
each rafter (Fig. A).
Move to the top of the panel and keep
spacing between the center of the
rafters. Secure with one 2" nail into
each rafter (Fig. A).
Nail the roof panel using 2" nails 6"
apart on edges and 12" apart inside
panel.
Attach the 23-7/8 x 35-3/8" upper roof
panel flush to first panel, flush at peak
4
and with the 1/4" measurement
(Fig. B, C ).
FINISH
5
Attach the lower roof panels flush to the
upper panels (Fig. D) and 3/4" on rafter
(Fig. E) and with a 1/4" measurement at
the gable trim (Fig. F).
Nail the roof panel using 2" nails 6" apart
on edges and 12" apart inside panel.
Repeat Steps 1-5 to attach roof panels
on the opposite side.
ROOF PANELS
x2
7/16 x 23-7/8 x 35-3/8"
(1,1 x 61 x 89,9 cm)
x2
7/16 x 23-7/8 x 23-7/8"
(1,1 x 61 x 61 cm)
22-1/4"
(56,5 cm)
23-7/8"
(61 cm)
23-7/8"
(61 cm)
11-1/2"
(29,2 cm)
3/4"
(19 mm)
Fig. E
(19 mm)
x2
7/16 x 11-1/2 x 96"
(1,1 x 29,2 x 244 cm)
3/4"
GAUGE BLOCK
Fig. A
NOTE:
Measurements from inside of panels
24"
24"
(61 cm)
(61 cm)
2" Nail
6" (15 cm)
12"
(30,5 cm)
Fig. C
23-7/8"
(61 cm)
Fig. F
3/4"
41
x170
2" (5 cm)
x2
7/16 x 11-1/2 x 35-3/8"
(1,1 x 29,2 x 89,9 cm)
24"
22-1/4"
(61 cm)
(56,5 cm)
1/4"
(6 mm)
7/16 x 23-7/8 x 35-3/8"
(1,1 x 61 x 115 cm)
Gable Trim
Flush
Fig. D
Gable
Trim
1/4"
(6 mm)
Flush
Fig. B
Advertisement
