Advertisement
PARTS REQUIRED:
x1
Ensure your wall frame is square by installing one panel and squaring frame.
4
Place the 48 x 72" panel onto wall frame with primed side up as shown. Measure and
mark overhangs and top spacing. Ensure measurements result in correct dimensions for
1" bottom spacing.
Use the gauge block to mark the 3/4" measurement on the wall stud. Secure panel with
two 2" nails in the top corners (Fig. A).
Move to the opposite end. Move the studs side-to-side until you have a 3/4" measurement
5
on the wall stud. Secure corner with a 2" nail. Move stud under center of panel to correct
dimension and secure with a 2" nail.
6
Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.
1"
(2,5 cm)
SIDE WALL PANELS
3/8 x 48 x 72"
(1 x 122 x 183 cm)
For squareness maintain 3/4" on stud and
5/8" at top plate.
BEGIN HERE
3/4" Gauge Block
6" (15 cm)
12" (30 cm)
3/4"
GAUGE BLOCK
There will be an
overhang at top.
5/8"
(16 mm)
24"
Center on mark
(61 cm)
30
x33
2" (5 cm)
1-11/16"
(4,3 cm)
Fig. A
Fig. B
2 Nails
2 Nails
Advertisement
