Advertisement
PARTS REQUIRED:
x1
Ensure your floor frame is square by installing one panel and squaring frame.
BEGIN
Attach the 48 x 96" panel with the rough side up (painted-grid lines side)
1
with the 48" edge and corner flush to the floor frame (Fig A). Secure panel
with two 2" nails in the corners.
Move to the opposite end. Using the long edge of the panel as a lever move the
2
panel side-to-side until the top corner is flush to the floor frame (Fig. B).
Secure panel with two 2" nails in the corners.
Check the floor frame is square by measuring diagonally across the frame corners.
3
If the measurements are the same your floor frame is square. The measurement
will be approximately 151" (385,5 cm) (Fig. C).
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
4
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Grid lines
Flush
(244 cm)
FLOOR PANELS (Not included)
5/8 x 48 x 96"
(1,6 x 122 x 244 cm)
12" (30,5 cm)
inside panel.
UP
6" (15 cm)
edges of panel
96"
Floor panels not included.
See page 3 for panel sizes and quantities.
Flush
(2) Nails
48"
(122 cm)
12
x55
2" (5 cm)
Flush at
opposite
corner
edge
Flush
151"
(385,5 cm)
151"
(385,5 cm)
Fig. A
(2) Nails
Flush
Fig. B
Fig. C
Advertisement
