Advertisement
PARTS REQUIRED:
x4
NX
x2
LEFT
BEGIN
1
You will be attaching trim NX from the backside of the gable panels (Fig. A).
You will assemble TWO RIGHT and TWO LEFT assemblies.
2
Place trim NX on floor.
Place a left or right gable panel onto trim primed side down (Fig.A).
3
4
Locate trim NX flush to edges and secure with six 1-1/4" screws 6" apart.
5
Repeat steps 1-4 to assemble two left and two right assemblies.
FINISH
You have finished building two sets of gable panel assemblies.
6
Set one left and one right aside. Continue building your back wall.
Use a 2x3"
on flat for support.
GABLE PANELS AND TRIM
2 x 3 x 35-7/16" (5 x 7,6 x 90 cm)
x2
RIGHT
Orient red ends to top.
Red ends of NX
Flush
NX
Primed side is down.
Flush
20
x24
1-1/4" (3 cm)
Fig. A
PRIMED
SIDE DOWN
6" (15,2 cm)
NX
Advertisement
