Advertisement
PARTS REQUIRED:
x1
7/16 x 35-3/8 x 96"
(1,1 x 89,9 x 244 cm)
Roof panels may cause serious injury
until securely fastened.
You must square the roof by attaching one panel fist. You will use the panels' long
edge as a lever to bring your roof into square. Commonly known as "racking".
BEGIN
1
Attach the 35-3/8 x 96" panel with the rough side up
(painted-grid lines side) with a 3/4" measurement on the
rafter (Fig B) and the panel flush at the peak (Fig. A).
Secure panel with two 2" nails in the corners.
Move to the opposite end. Using the long
2
edge of the panel as a lever move the
panel side-to-side until the top corner is
flush to the peak (Fig. C) and there is 1/4"
measurement to the gable trim (Fig. D).
You may need to move your back wall to
get the 1/4" measurement. Secure panel
with two 2" nails in the corners.
ROOF PANELS
3/4"
GAUGE BLOCK
Fig. B
1/4"
(6 mm)
Gable
Trim
1/4"
Fig. D
(6 mm)
40
x4
Gauge
Block
3/4"
Flush at peak.
(1,9 cm)
2" (5 cm)
Flush at peak.
Fig. A
Two Nails
Fig. C
Advertisement
