Advertisement
Step 37
You will need:
4 x Cam Bolts
4 x Cam Nuts
Ø5 x 45 mm
Ø14.5 x 11.9 mm
(H1)
Phillips head
screwdriver
-Screw 4 x Cam Bolts (H1) into 2 x Panels (P33).
- Attach 2 x Panels (P33) to 2 x Panels (P10)
- Insert 4 x Cam Nuts (H2) into 2 x Panels (P10)
make sure the arrow is pointing to the hole.
-Turn the Cam Nut (H2) 90
Step 38
You will need:
2 x Large Bolts
2 x Barrel Nuts
Ø9.5 x 11 mm
Ø6 x 50 mm
(H3)
Phillips head
Flat head
screwdriver
screwdriver
- Attach Panel (P30) to Panel (34).
- Insert 2 x Barrel Nuts (H4) into Panel (P30).
- Screw 2 x Large Bolts (H3) through Panel (P34) into Barrel Nuts (H4) in Panel (P30.)
- Remark: Adjust position of Barrel Nuts (H4) by Flat head screwdriver if necessary.
Hold Panel (P30) to avoid them from falling to damage the parts or
structure until the end of Step 36.
www.fantasticfurniture.com.au
This is how a cam nut works........
(H2)
◦
clockwise to tighten.
(H4)
The head of the cam
bolt goes into the
open mouth of the
cam nut. You then turn
the cam nut so it
tightens over the bolt.
H1
P30
P30
P34
H4
X2
P10
H2
P33
H3
P34
PAGE 29
Advertisement
