Page 3
What You Need To Assemble the Chair Phillips Head Screwdriver (Tools not provided) 1 x CENTER APRON 1 x SEAT FRAME 1 x BACK FRAME (P3) (P2) (P1) 2 x SIDE APRON 2 x FRONT LEGS 1 x BOTTOM SEAT COVER (P4a, P4b) (P6) (P5a, P5b)
Page 4
Step 1 You will need: 1 x Washers (H1) 1 x Short bolts (H3) (P2) (H3) (H1) (P1) Attach Seat Frame (P2) to Back Frame (P1) using 1 x Short Bolts (H3) and 1 x Washers (H1) and hand tighten to 80% . Step 2 You will need: 4 x Washers...
Page 5
Step 3 You will need: 2 x Timber Screws (H4) (H4) (P4b) (P3) (P4a) Insert Center Apron (P3) into Side Aprons Space (P4a and P4b), keeping Side Aprons screw holes facing down.Then use 2 x Timber Screw (H4) to secure Side Aprons to back leg.Turn by Phillips Head Screwdriver until fully tightened.
Page 6
Step 4 You will need: (H1) 4 x Washers (P5) (H1) (H3) 4 x Short bolts (H3) NOTE: LEG GOES FLUSH INTO CORNER Note:To make it is easier, place the seat over a table. Insert Front Leg (P5a) into Side Apron (P4a) and insert Front Leg (P5b) into Side Apron (P4b). Ensuring legs fit into Seat Frame (P2).
Page 7
Step 6 Apply hardward pressure on the seat pad to ensure the chair is level before tighten all bolts fully with allen key. Step 7 You will need: 1 x Bottom seat cover (P6) (P6) Attach bottom seat cover (P6) to underneath of chair. Page 7...
Page 8
Step 8 The job is now complete! In the interest of our environment Please dispose of all packaging thoughtfully Page 8...