Advertisement
Step 11
You will need:
2 x Large Bolts
2 x Barrel Nuts
Ø6 x 50 mm
Ø9.5 x 11 mm
(H3)
Phillips head
screwdriver
screwdriver
- Attach Panel (P11) to Panel (P2).
- Insert 2 x Barrel Nuts (H4) into Panel (P11).
- Screw 2 x Large Bolts (H3) through Panel (P2) into Barrel Nuts (H4)
- Remark: Adjust position of Barrel Nuts (H4) by Flat head screwdriver if necessary.
Hold Panel(P11) to avoid them from falling to damage the parts
or structure until the end of Step 13.
Step 12
You will need:
1 x Cam Nuts
Phillips head
Ø14.5 x 11.9 mm
screwdriver
(H2)
-Attach Panels (P8),(P10) to Panel (P2).
-Insert 1 x Cam Nut (H2) into Panel (P10)
make sure the arrow is pointing to the hole.
-Turn the Cam Nut(H2) 90
-Remark:Hold Panels (P8)&(P10) to avoid them from
falling to damage the parts or structure until the end of Step 13.
www.fantasticfurniture.com.au
(H4)
Flat head
This is how a cam nut works........
◦
clockwise to tighten.
P2
H3
P2
The head of the cam
bolt goes into the
open mouth of the
cam nut. You then turn
the cam nut so it
tightens over the bolt.
P2
P2
H1
P11
P11
H4
P10
P8
P10
H2
PAGE 12
P8
Advertisement
