Bay-Tek PRIZE HUB Modular Service Manual page 65

SPINDLE HUB TROUBLESHOOTING GUIDE
Problem
No lights on at all in
Spindle Unit
Spindle Not Turning
Test dispense a prize by going
into menu and selecting a
locker.
Spindle Always Turning
Prize does not Drop
or
More than One
Prize Drops at a
time.
Spindle will turn off
after prize chute
sensors "sees" prize
drop.
The spindle will turn
for 35 seconds - if the
prize does not fall
from spindle, or gets
stuck in the prize
chute, it will not seen
by prize chute sen-
sors. It will show that
prize unavailable, not
subtract tickets from
guest and have him
chose a different
prize.
Troubleshooting Chart
Probable Cause
12 Volt power comes from
Main Unit's power supply.
Disconnected, loose or
broken wires.
Faulty 1803 board.
Check for 12 Volts DC on
spindle motor
Disconnected, loose or
broken wires.
Faulty controller board.
Spindle will time out and
stop spinning after 35
seconds in any mode.
Prize is Make sure prize hanger is UNDER retaining pin.
stuck on
spindle.
Inspect prize chute and clear jam.
Prize stuck
in prize
chute Clean emitters and detectors. Ensure they are pointing straight out
and no components on boards are bent
Prize chute To remove sensors: Remove 4 of #2 square head screws from L Brackets
in rear of prize chute wood box. Wood Box will now slide out front of game.
sensors are
Remove Prize Chute Sensor by removing the 4 Phillips bolts that secure
dirty, misa-
sensor to black plastic mask.
ligned, or
(The black plastic masks must remain attached to wood to provide
faulty.
alignment for the sensors.)
Inspect cables between sensors and to 1803 board. (AACE1818,
AACE1823) Replace if needed.
Ensure AACE1823 cable is plugged into correct socket on 1803
board. (Gold socket) See diagram.
Replace both Prize Chute Sensors. (AACB4402)
Replace 1803 Control Board. (AACB1803)
Verify main unit has 12 Volt lights. Verify
12 Volt jumper cables that feed 12 volts
are connected to Spindle Unit
Check connections from LED lights to
1803 board. Replace if needed.
(AACE1815, AACE1819, AACE1820)
Replace AACB1803 board
If spindle motor has 12 VDC, and does not
move - Replace spindle. (AADSPZ010)
If no 12 VDC:
Check connections from spindle to
controller board. (AACE1821, AACE1822)
Replace controller board. (AACB1803)
If spindle continues to spin, the controller
board is faulty.
Replace board. (AACB1803)
65
Remedy
AACB4402