Bay-Tek PRIZE HUB Modular Service Manual page 16

Version Information
Version Information will bring up the Version Menu.
This will show motherboard software version,
I/O board software version
Attached Hub software versions.
This will also show the selected Kiosk Input type.
Module Status Information
Shows the status of the connected Hubs.
Module 1 is the Spindle Hub:
Normal operating condition is (Spindle Unit Waiting)
If a sensor is blocked, there is a delay to be shown.
Module 3 the Capsule Hub:
Normal operating condition is (Capsule Tree Waiting)
The numbers should be cycling from 0 to 180, and back to 0.
If numbers are not cycling, the carousel is not turning.
If Capsule Tree Door Open, check door interlock switch.
Module 3 the Locker Hub:
Normal operating condition is (Doors Closed and Locked)(0)
If the (0) is a different number, a door is open.
Check switch behind locker through side door.
Reset Printer
If "Print Jobs" is not 0 , touch "Reset Printer" to clear print jobs.
The Prize Hub must then be powered down, wait 10 seconds, and power
back on.
DIAGNOSTIC MENU
16