Embed - Bay-Tek PRIZE HUB Modular Service Manual

EMBED OPTIONS

Embed

Plug in an Ethernet cable to the port shown on the main
board (inside the Main Hub), and out through the hole in
Part # AAKIT-PH-READER
the bottom of the cabinet.
Mount your card reader according to manufacturer
instructions, and plug the Ethernet cable into your card
reader server.
Adjust the Kiosk Interface in the location menu to show
"Embed"
Enter Network Setup Menu
Please leave the Prize Hub Network disabled.
Set the Card Server. This is IP address of your server.
It should be in a similar format as shown.
Set Port number. This is the port number of your server.
It should be in a similar format as shown.
Set username and password for your specific card
system network.
This allows you to connect to Embed server.
Please contact your local Embed support if any
questions or problems with username/password.
USA # (469)521-8000
Europe # 44 (0)1225 311 323
Note: It is important to note if the IP address has a
leading 0 in the octet.
So in this example:
064.126.017.030 is NOT the same as 64.126.17.30
Please be aware and type it in the Prize Hub exactly as
you are given by the card swipe company.
33