How To Load Printer Paper; Marquee Installation - Bay-Tek PRIZE HUB Modular Service Manual

HOW TO LOAD PRINTER PAPER

Remove the plastic disk and the empty paper core from the spool holder.
Slide a new roll of paper onto the spool and replace the plastic disk.
Feed the end of the paper into the opening until it grabs and begins to feed
through the printer.
The watermark should be facing up as the paper enters the printer.
The printer will only print on one side of the thermal paper.
Tools Needed:
2 people
Drill with #2 square bit
Un-package the marquee and locate the hardware packet; set aside.
Team-lift the marquee onto the top of the Prize Hub. One person will have
to hold the marquee up while the other directs them to center it.
Secure the marquee in place with included black wood screws.
Feed the marquee cable through the hole in the top of the Main Hub, and
plug in to cable clamped near the cabinet ceiling; it is labeled
"MARQUEE".
Make sure the marquee is lit up, then clamp the cables to the cabinet as
necessary.

MARQUEE INSTALLATION

40