Bay-Tek PRIZE HUB Modular Service Manual page 55

MAIN UNIT TROUBLE SHOOTING GUIDE
Problem
No power to the game.
No lights on at all.
(Power Supply not ON)
Monitor shows nothing at
all on power on.
Check for green LED on
monitor control unit.
A5MO1800
Touchscreen
Monitor
Probable Cause
Unplugged
Circuit breaker tripped
Power strip faulty
GFCI Outlet Plug defective.
Line Filter defective
Check AC cord from power
strip into Power supply
Ensure Power Supply switch
is set to 115V (Some power
supplies may not have this)
Ensure power rocker switch
is on.
Power supply shutting down
because of 12 V overload
Push ON button on monitor.
Power cable unplugged from
monitor.
Power strip faulty
Faulty power supply for
monitor
Re-Boot game and check for
any errors on monitor.
Power game down, wait 10
seconds, then power game
ON to reset.
Faulty monitor.
Blurry Monitor - Too bright, or dim.
Press the "Auto" button on control unit to select Auto Adjustment.
This may take a few seconds.
Verify that the screen looks good and image is centered.
55
Remedy
Check wall outlet
Reset power strip breaker switch or building
circuit breaker
Change plug position, replace if needed
(AACE1817)
Ensure 110 Volts is getting to Power Strip
Replace plug if needed. (A5PL1800)
Ensure 110 Volts is getting to Power Strip
Replace filter if needed. (A5FI9020)
Ensure power in cord is tight
Check this is applicable
Set rocker switch to ON (-)
Refer to power supply diagnostics to isolate
bad component. A bad motor or 12 volt short
could cause this.
Ensure power is plugged into side of
monitor, down to power strip.
Change plug position, replace if needed
(AACE1817)
Check A5CORD5 to ensure 110 volts to
monitor power supply.
If error shows on monitor, refer to sugges-
tions below.
If monitor has power, the touch works and
makes touch sounds, the monitor is faulty
Replace monitor. (AAMO1810)