Space Requirements; Machine Positioning - Primus MB 90 Installation And Maintenance Manual

www.groupdynamics-laundry.com
sales@groupdynamics.lv
Fig.4.1.E. Hanging eyes for the hook
suspension

4.2. SPACE REQUIREMENTS

REQUIRED MACHINE WORKING CONDITIONS:
See chapter „3. TECHNICAL SPECIFICATION".
The machine must not be installed within the reach of directly spraying water. Do not install the machine
where it will be exposed to weather condition and excessive humidity. When steamed up due to temperature
changing, water must not run over the machine walls and covers, nor to cover the floor under and around it.
SIZE OF A LAUNDRY ROOM
IGNORING THE REQUIREMENT FOR SPACES BETWEEN MACHINES AND WALLS CAN MAKE
SERVICE AND MAINTENANCE WORK DIFFICULT.
Total space requirements for the system installation are usually determinate by a detailed plan of the building.
The machine dimensions are stated in the chapter „3. Technical specification". Leave min. 0,8 m/2,6 ft free
space between the machine left side and the wall, where the machine stands for the maintenance access.
Also between the machine right side and the wall or another machine leave free space minimally 0,8 m /
2,6 ft, see fig. 4.3.A. The waste piping or outlet channel must be dimensioned to the discharged water quantity
and a number of washing machines.

4.3. MACHINE POSITIONING

CARRYING CAPACITY OF THE FLOOR
WARNING !
!
IT IS RECOMMENDED TO CONSULT STATIC REQUIREMENTS WITH A STATIC ENGINEER TO MEET
THE REQUIREMENTS OF PERMISSIBLE LOADING, VIBRATIONS AND NOISE LEVEL IN THE BUILDING!
THE MANUFACTURER DOES NOT RECOMMEND TO INSTALL THE WASHING MACHINE IN A ROOM
WITH A CELLAR OR ON A FLOOR HAVING ROOMS BENEATH.
WARNING !
!
IN CASE OF INSTALLATION IN A ROOM WITH A CELLAR OR ON A FLOOR HAVING ROOMS BENEATH:
THE INSTALLATION MUST BE APPROVED BY A STATIC ENGINEER TO MEET THE REQUIREMENTS
OF PERMISSIBLE LOADING, VIBRATIONS AND A NOISE LEVEL IN THE BUILDING.
THE MANUFACTURER IS NOT RESPONSIBLE FOR SUCH EFFECTS.
FASTENING THE MACHINE
WARNING !
!
THE MACHINE MUST ALWAYS BE FIXED TIGHTLY TO THE FLOOR AND MUST FIT RELIABLY
TO THE FLOOR IN ALL FOUR SPOTS INTENDED FOR FIXING THE MACHINE!
The machine is to be located on a levelled concrete floor to comply with static and dynamic stress of the machine.
Check the position of the machine base frame by a water level. The manufacturer is not responsible for
consequences caused by a wrong installation.
It is expected to use anchoring bolts, (see appendix A) for fixing the machine to the floor. It is also possible
to use a suitable outlet channel for the waste water, fig.4.3.B, unless the machine is connected to a drain pipeline.
WARNING !
!
THE NUTS OF THE ANCHORING BOLTS HAVE TO BE TIGHTENED BY MEANS OF A TORQUE,
SEE APPENDIX A. DO NOT TIGHTEN NUTS OF ANCHORING BOLTS BEFORE THE CONCRETE BASE
AROUND THE BOLTS IS COMPLETELY HARDENED.
513289 PUBLICATION DATE 07/04 INSTALLATION AND MAINTENANCE MANUAL 9