Table of Contents
Advertisement
4. MACHINE INSTALLATION
4.1. MANIPULATION AND UNPACKING
DURING TRANSPORTATION
All doors and passages the machine is to be transported through during installation must be reasonably
dimensioned to meet the width, height and depth off the machine including the package. The machine
dimensions are stated in chapter „3.Technical information".
UNPACKING
The machine is delivered to the customer in a cardboard packing, on wooden skid and the machine is
additionally protected by polyethylene foil. If possible, leave the machine in transporting package until the
machine connection in the laundry.
ACCESSORIES DELIVERED WITH THE MACHINE
After unpaking check if all accessories have been delivered according to your order.
4.2. SPACE REQUIREMENTS
WORKING CONDITIONS OF THE MACHINE
The machine is not designed to be placed in an environment where it can come into contact with splashing
or spraying water. Do not store or install the machine where it can be subject to environmental conditions
(rain, wind) or extreme humidity. When the machine bedews as a result of sudden climate change, the water
must not run down the walls or covers of the machine or cover the floor.
REQUIRED ROOM DIMENSIONS
Provided that the requirements in respect to room dimensions are not met, the maintenance of the fixed
or inbuilted machine may be difficult.
Leave at least a 0.6m / 24" free space between the rear panel of machine and the wall. Leave at least
0.04m / 1.6" free space between the side panel of the machine and the wall or other machine. Leave
at least 0,6m / 24" free space between the upper cover and the wall.
4.3. FASTENING THE MACHINE
The machine is too be located on a leveled floor which complies to static and dynamic stress of the
machine. Check the position of machine top by a water level and adjust machine legs (fig.3.1., pos.20).
WARNING !
! !
IF THE MACHINE IS LOCATED ON A HIGHER BASE FOR BETTER OPERATION, THE FRONT LEGS
OF THE MACHINE SHOULD BE LOOCKED FOR SAFETY REASONS (SEE FIG. 4.3.).
Do not forget to leave an access space to the lever of emergency door opening (fig.4.3.,pos.2), which is
located in the bottom left front machine part.
6
INSTALLATION AND MAINTENANCE MANUAL
PUBLICATION DATE Jan 06
516574
Hide quick links:
Advertisement
Table of Contents
