Accessory Instructions - Uplift Desk V2 Standard 4-Leg Height Adjustable Frame Manual

Hide thumbs Also See for V2 Standard 4-Leg Height Adjustable Frame:

Table of Contents

Now is a good time to install accessories such as wire management, CPU holders, keyboard trays, or anything

else that fastens to the bottom of your desk. This section will cover accessories that are included with this

Frame. For additional accessories, refer to the instructions that came with those accessories.

ACCESSORY INSTRUCTIONS

Desk Cable Management:

Use the included Cable mounts (H9) to organize your

wires, keep a clean presentation, and prevent any wires

from snagging on anything when adjusting height. The

Cable mounts work best when stuck directly to the

metal desk frame. Attach Cable mounts to the inside

of frame parts. You might want to save some for once

you have everything on your desk plugged in.

Installing Wire Management Tray:

If you will have a lot of wires to wrangle, install the Wire

management tray while assembling your desk. Assess

where your wires may be concentrated. Move it un-

til you find the placement you want, and make a pencil

mark at each hole's location.

Attach tray to your desk using two (2) #10x5/8'' Wood

screws (H14).

If you own a drill, you can make pilot holes to make this

a little easier. Use it with a 1/8" diameter drill bit and,

ensuring that you DO NOT DRILL DEEPER THAN 1/2",

drill pilot holes where you've made your marks.

Step 14

Double check that all accessible screws on the desk

are tight.

And then check all screws again and make sure they're

tight. This isn't a typo, it's important and it's far easier to

tighten them with the desk upside down than it is later.

Be careful not to miss the screws marked with an ar-

row in the diagram.

Table of Contents

Do you have a question about the V2 Standard 4-Leg Height Adjustable Frame and is the answer not in the manual?